「Solo」の版間の差分
(英語版へのリンクを追加) |
Kusanaginoturugi (トーク | 投稿記録) (序文を飜訳) |
||
| 5行目: | 5行目: | ||
{{Related articles end}} |
{{Related articles end}} |
||
| + | [https://solokeys.com/ Solo] は、オープンソースの FIDO2 セキュリティキーです。この記事では、その設定方法と使用方法について説明します。 |
||
| − | The [https://solokeys.com/ Solo] is an open-source FIDO2 security key. This article describes how to set up and use it. |
||
== Introduction == |
== Introduction == |
||
2022年1月17日 (月) 13:48時点における版
関連記事
Solo は、オープンソースの FIDO2 セキュリティキーです。この記事では、その設定方法と使用方法について説明します。
目次
Introduction
The Solo (or SoloKey) is a small USB Security token supporting Universal 2nd Factor (U2F) requests, thus acting as a second factor for authentication. It also supports the newer FIDO2 standard allowing for passwordless logins.
Compared to a YubiKey it offers less features but supports firmware upgrades to extend the functionality in the future. Both hardware and software are released as open source.
Installation
Special drivers are not required for the key to work. It is recommended to install the Solo software and upgrade the firmware of your Solo.
Upgrading the firmware
Managing your Solo, e.g. upgrading the firmware or setting a PIN, requires the solo-pythonAUR package. After installing the package, first check if your key is detected.
$ solo ls
:: Solos 123456XXXXXX: SoloKeys Solo 3.0.1
Then you can use solo key update to perform a firmware upgrade, solo key set-pin to set a PIN, and solo key change-pin to change your pin.
Test the Solo in your browser
Visit the Webauthn demo, type in a username and click on "Register". Your Solo's LED will flash until you click it. After that, you can login to the page only using your Solo, no need for username or password.